This is an example of a virtual downloadable product. It can be downloaded by a customer from your site.

  • Well-organized layers

  • Easy to modify

  • Vector shapes

  • Transparent background

SKU: FlexiForceA201 Category: Tags: ,


FlexiForce® A201 Sensor

A201 sensors are trimmable and have a 3-pin male connector. We highly recommend you use A201 sensors with our Quickstart Board (pictured below), a finished single voltage source circuit, if you are not using your own electronics or multimeter.

The sensors are available in three force ranges: Low 4.4 N (0 – 1 lb), Medium 111 N (0 – 25 lb) and High 445 N (0 – 100 lb)*. The force ranges stated are approximations. The dynamic range of this force sensor can be modified by changing the drive voltage and adjusting the resistance of the feedback resistor.

How to Adjust the Force Range:

*In order to measure forces above 100 lb (up to 1000 lb), apply a lower drive voltage (-0.5 V,-0.10 V, etc.) and reduce the resistance of the feedback resistor (1kΩ min.) Conversely, the sensitivity can be increased for measurement of lower forces by increasing the drive voltage or resistance of the feedback resistor.

For an alternative to the recommended circuit, try our FlexiForce®Quickstart Board. This is a finished single voltage source circuit which can be quickly dropped into a prototype or easily designed into a product to obtain force measurements.

Typical Performance

Linearity (Error):  < ±3% (Line drawn from 0 to 50% load)

Repeatability:  < ±2.5% of Full Scale (Conditioned Sensor, 80% of Full Force Applied)

Hysteresis:  < 4.5 % of Full Scale (Conditioned Sensor, 80% of Full Force Applied)

Drift:  <5% / logarithmic time (Constant Load of 25lb (111 N))

Response Time:  < 5 µsec (Time required for the sensor to respond to an input force; Impact load – recorded on Oscilloscope)

Operating Temperature:  -40°C – 60°C (-40°F – 140°F)*

* Force reading change per degree of temperature change = 0.36%/ºC (±0.2%/ºF)

Additional information

Dimensions 700 x 600 cm


There are no reviews yet.

Leave Comment
Be the first to review “FlexiForce Sensor”

Your email address will not be published. Required fields are marked *

clear formSubmit